5
5
PRODUCT SAFETY INFORMATION
•
Make sure to read the tractor and/or front loaders manual.
•
Connect only the equipment to approved tractor or suitable tractor or front loader
•
Read the machine’s instruction manual. Always check the performance and the machine
combination that are use. It’s highly important these matches in a satisfactory manner.
Regularly inspect the machine/equipment before use
•
Never put your hands or feet under the machine without first stopping the equipment
and the tractor’s engine
•
Never leave the machine with the tractor’s engine running. Switch off the engine and
apply the parking brake when leaving the implement - even for a short while.
•
Always disconnect the machine before performing any service or maintenance work.
•
Only the operator may be in the vicinity of the machine during work. The machine is
made for single work only.
•
Do not let anyone climb on the blade
•
Never leave the machine uplifted. The tractor hydraulics can loose pressure and the
equipment can fall down uncontrollably.
•
Make sure all protective device are correctly mounted and can not come loose.
•
Do not let another person operate the machine until you have assured that the person
have the necessary knowledge of the machine.
•
Limit the transport speed to a maximum of 30 km/h, unless the machine is marked with
another allowed speed.
•
Do not stand between tractor / front loader and diagonal blade when attaching and
detaching it from the tractor/front loader
•
The operator should have a good knowledge of the areas that are to be cleared from
snow and have a good foresight on how the areas are to be cleared. Place boarder
markings, eg mark well rings, level differences, steps, wells, broken or damaged asphalt /
paving, remove large rocks or other debris that may be overrun by the blade, etc.
•
Check that the tractor / front loader tires are pumped with the correct pressure. (Read
the tractor / front loader’s manual)
Warning!
For safety, this product should only be used in the manner described in this man-
ual. The user is responsible for the instruction to be read through and followed.
