Kellyco GOLD FINDER, User Manual

Au GOLD FINDER Assembly

Page 1

1

Loosen the twist lock on upper s-shaft before 

mounting the mid-shaft to the upper shaft. Press 

down the pin in mid-shaft, engage the pieces 

together by inserting mid-shaft into upper s-shaft 

being careful to align pin in shaft with alignment 

hole in upper s-shaft. Slightly rotate mid-shaft 

during insertion until pin clicks into place in upper 

s-shaft alignment hole and tighten the twist lock. 

Twist lock need only be hand tight to engage. 

To attach the system box to the upper shaft, insert 

the thumb-screw through the hole. Then, place the 

thumb-screw in threaded mount point (threaded 

bronze plug) on underside of system box and 

firmly tighten.

Insert the washers on the lower shaft yoke. 

Carefully insert the lower shaft yoke between 

search coil mount tabs. Insert non-metallic lever 

bolt through coil mount tabs. Install and tighten 

non-metallic winged nut onto the threaded lever 

bolt and securely tighten. 

Loosen the twist lock on mid-shaft before 

mounting the mid-shaft to the lower shaft. Press 

down the pin in lower shaft, engage the pieces 

together by inserting lower shaft into mid-shaft 

being careful to align pin in shaft with alignment 

hole in mid-shaft. Slightly rotate lower shaft during 

insertion until pin clicks into place in mid-shaft 

alignment hole and tighten the twist lock. Twist 

lock need only be hand tight to engage. To adjust 

length of metal detector shaft, simply loosen the 

mid-shaft twist lock and depress lower shaft spring 

tab. Simultaneously rotate lower shaft slightly and 

shorten or extend to lower shaft to desired length, 

re-align spring tab into desired alignment hole and 

retighten mid-shaft twist lock. 

Carefully spool the search coil cable (do not twist 

or stretch) onto the lower and mid-shafts. Insert 

the cable connector into the system box input 

socket and secure by tightening the nut. Do not 

pull on cable when removing coil cable connector 

from System Box.

Insert armrest strap through its slot as shown in 

the figure. Adjust armrest position by loosening 

fasteners and sliding armrest forward / rearward to 

desired position and retighten fasteners. 

1

2

3

4

5

6

3

4

5

6

2

S-shaft

Mid-shaft

Lower Shaft

Search Coil

System Box

Armrest