Kelvin Hughes
MANTA
DIGITAL
TM
Quick Start Guide:
Chapter
5
:
Go to Run …
HBK-4002, issue 2 February 2013
Page
18
of
26
5.2 Dual radar display
Transceiver activation from standby screen
When
dual radar display
mode is started, the transceiver selected as
Master
in the standby
screen is set to
Run
causing it to transmit and the antenna to rotate.
Setting the system back into Standby stops a mastered transceiver but
does not
switch it
OFF.
Dual radar display tabs
There are a number of tabs in the upper right hand side of the screen:
PPI tab
The PPI tab displays a secondary image from the
transceiver
currently selected by the main PPI
.
Cursor position
: A box below the gain control gives the
range, bearing and position of the cursor within the 2
nd
PPI.
The following functions can be adjusted independently of
the primary PPI:
Screen orientation (N-UP, C-UP, H-UP).
True or relative motion.
Ownship/ screen offset.
Increase/ decrease range.
Control of trails.
Routes ON/ OFF.
ARPA & AIS targets ON or OFF.
HL suppression.
Gain control.
ARPA/ AIS targets:
When acquired, all radar tracked targets and AIS targets will be
displayed on both the primary and secondary PPI regardless of which display initiates the
tracking.
HAP tab
If connected to a compatible sensor, the HAP tab displays
information for bow thrusters, propulsion systems, rudder,
wind and depth.
Note 1
: Apart from changing the display of Wind from true to relative,
there are no operator adjustable parameters in the HAP tab.
Note 2
: The layout of the HAP tab changes depending on the sensors
configured during commissioning.
On interswitched
systems, firstly
select the desired
transceiver.
From the standby
screen select
Dual
Radar Display.
