Kelvinator KGC20BLA, Installation Manual

13. If a remote controller has been installed, check that the 

controller operates correctly (refer page 13 of  
this manual).

PRIORITY

°C

BURNER ON

PRIORITY

°C

BURNER ON

ON/OFF

PRIORITY

HOT

COOL

MADE IN JAPAN

Main

ON/OFF

PRIORITY

HOT

COOL

MADE IN JAPAN

Shower

PRIORITY

°C

BURNER ON

ON/OFF

PRIORITY

HOT

COOL

MADE IN JAPAN

Ensuite

The gas continuous flow hot water system should now be 
operating correctly.

Now that commissioning has been completed and the gas 
continuous flow hot water system has been set up to operate 
correctly, select the correct model number of the water 
heater on page 5 of the user manual. Fill out your details, the 
serial number, installation date and include any important 
notes to the customer. The user manual is then to be handed 
to the customer or left in a suitable location on the premises. 
If the customer is available they are to be instructed on 
the safe and correct operating of the water heater and any 
auxiliary equipment.

 If the hot water system isn’t going to be used for a long time 
and needs to be turned off after commissioning, follow these 
instructions:

•  Switch off the electrical supply at the power outlet that 

the water heater is plugged into

•  Close the gas isolation valve located on the inlet to the 

water heater

•  Close the cold water isolation valve located on the inlet to 

the water heater

Note: If there is a risk of freezing conditions, do not switch off 
power to the water heater unless it is drained of water first. 
Please see the section on freeze prevention on page 9 of the 
user manual for more information.

Commissioning instructions 

(continued)

 Kelvinator Gas Continuous Flow hot water system 

 commissioning instructions  17