Kelvinator KGC20BLA, User Manual

8  operation  

Kelvinator gas continuous flow hot water systems

Normal  operation

With the remote controller (KGCMRCA) installed

1.   Press the ON/OFF button to activate the display on  

the controller.

2.  Press the PRIORITY button and ensure that the priority 

lamp is lit.

3.   Set your desired temperature. This systems allows you to 

set your water temperature between 37°C and 55°C. 

Note: If a tempering valve is installed as part of the 
installation, the water temperature will not be able to go 
above the setting on the tempering valve e.g. 50°C.

4.   Turn on your hot water tap.
5.   Ensure that the BURNER ON display indicator is lit.
6.   Turn off your hot water tap.
7.   Ensure that the BURNER ON display indicator is off.

PRIORITY

°C

BURNER ON

ON/OFF

PRIORITY

HOT

COOL

MADE IN JAPAN

Main

priority lamp

priority button

burner on 
lamp

KGCMRCA 

ON/OFF button

burner on lamp

display set temperature

40

NOTE: If power to the hot water system is lost then re-set, 
the remote controller will also lose power and switch off. If 
the water is still running during this time it will go cold, until 
the remote controller is switched on returning to default 
temperature setting of 40°C. The temperature can then be 
adjusted back to the desired temprature

Please note the following flow rates to properly operate the 
hot water system:
•  Flow rate to activate the water heater:  

3.0 litres per minute 

•  Flow rate to keep the water heater running: 

2.5 litres per minute 

Without the remote controller

1.   Open a hot water tap. 

2.   Mix cold water with the hot to get the correct 

temperature water. 

3.   Close the hot water and cold water taps.