WARNING
caution
•
Do not operate the air conditioner for long periods with the
air flow direction set downward in cooling or dehumidifying
mode. Otherwise, condensation may occur on the surface of
the horizontal louver causing moisture to drop on to the floor
or on furnishings.
•
After a quick restart, the horizontal louver may remain static for
approximately 10 seconds.
•
Open angle of the horizontal louver should not be set too
small, as COOLING or HEATING performance may be reduced
due to too restricted air flow area.
•
Do not move the vertical (up/down) louver manually, otherwise
the vertical louver will be out of sync. But if this happens,
please cease operating, switch off power for a few seconds,
then restart the air conditioner.
Optimal operation
To achieve optimal performance, please note the following:
•
Adjust the air flow direction correctly so that it is not towards
people.
•
Adjust the temperature to achieve moderate comfort levels.
Excessively low or high temperature waste energy.
•
Improve performance by keeping windows and doors closed.
•
Limit energy usage (run time) by using the TIMER function.
•
Do not put any object near air inlet or air outlet, as the
efficiency of the air conditioner may be reduced and may
cause the air conditioner to stop running.
•
Inspect and clean the filters every 3 months or as required.
Ensure that the filters are correctly inserted after cleaning.
The direction of airflow can be adjusted for maximum comfort.
Adjusting vertical air flow (Up/Down)
The vertical airflow direction is controlled by using the remote
control. This can be set to a fixed direction or to automatically
swing up and down for even air distribution. Refer to Remote
Control section page 9 for operation details .
Adjusting horizontal air flow (Left/Right)
•
The airflow can be directed horizontally (left to right) by
manually adjusting the deflector rod.
TIPS & INFORMATION
important
Do not put your fingers into the panel of the blower and suction
side. The high-speed fan inside may cause injury.
Airflow directional control
Range
Deflector rod
Range
15
Airflow directional control