Kemlan XL, Installation & Operating Instructions Manual

2

TECHNICAL SPECIFICATIONS

*As per Clause 3.3.3 of AS/NZS 2918 for floor protector 

construction requirements.

Where a sample appliance installation (or prototype 

installation) has not been tested, the floor protector 

shall extend either to a distance of not less than 500mm 

(measurement 

C

) beyond any part of the appliance or a 

lesser distance at which it forms a abutment with a wall or 

heat shield (subject to the requirements of Clause 3.2).

Heating capacity of this appliance is given as a guide only 

and may vary depending on the climate zone and type 

of dwelling (floor plan and degree of insulation).  Consult 

your local authorised distributor to determine realistic 

expectations for your home.

Heat output and fuel consumption of this appliance 

is dependent on the moisture content, size, loading 

geometry and the type of hardwood used.

The appliance complies to the safety standards AS/NZS 

2918.  When in use some parts may become hot.  A 

suitable fireguard is recommended where the very young, 

elderly or infirm are concerned.

CONSTRUCTION

- 6 & 8mm heavy duty steel firebox – fully welded

- 25mm thick firebrick lined floor

- 19mm ceramic lined sides and baffle

PERFORMANCE

- Heating capacity – 220-320m2 (23-33 squares)

- Peak heat output – 21.6kW

- Average output – 2.0g/kg

- Average efficiency – 61%

Glass viewing area

- 602mm wide x 302mm high

Flue pipe

- ø150mm – top exit

Shipping weight

- 215kg

All dimensions shown are approximate.  Check all 

dimensions accurately before installation.  Before 

installing refer to the installation instructions.  

In line with our policy of continuous improvement, we 

reserve the right to alter specifications without notice.

A - 

100mm

B - 

550mm

C - 

150mm

D - 

3200mm

E - 

945mm

F - 

620mm

G - 

1200mm

H - 

1060mm

I* - 

500mm

STANDARD INSTALLATION

MINIMUM CLEARANCES FOR THE KEMLAN XL SOLID FUEL 

APPLIANCE INSTALLED WITH A DEFAULT FLUE KIT

CORNER INSTALLATION

I*

I*

NOTE:

The floor protector consists of a 12mm thick cement fibre sheet 

which has a thermal resistance of 0.8² k/W, per 4mm thick sheet

A

C

C

F

F

H

D

G

B

E