Owner’s manual
EN
9
PROGRAMMING
The lamp sockets and remote control have been pre-set and can be used
immediately.
To re-program the remote control and a socket receiver, follow the
instructions below:
1. Turn off the power of the socket.
2. Press and hold the ON button of the desired socket number on the
remote control you wish to program for about 5 seconds while turn
on the power.
3. The LED indicator on the bottom of socket will begin to flash.
4. While still holding the button pressed, wait until you hear a ‘click’ sound
from the lamp socket and the LED indicator will stop flashing.
5. Release the button. Re-programming operation has been successful.
Note: one button on remote transmitter can program one or more lamp
sockets, but one lamp socket can be only programmed and matched by
one button.
REMOTE CONTROL BATTERY INSTALLATION
Regularly change the battery in the remote control for optimum operation.
However, if you find the socket not responding or the indicator light becomes
dim, change the battery of the remote control:
1. Slide the battery compartment cover to open it.
2. Install one A23 (12 V) battery. Note the correct polarity.
3. Close the battery compartment.
TROUBLESHOOTING
In case, one of the sockets do not respond to the remote control, follow the
steps below:
1. Replace battery in remote control
2. Make sure the socket is correctly installed in existing bulb socket.
3. Re-program the sockets and remote according to “Programming”
paragraph in this instruction manual.
