Safety
DX,PAINT -19-24JUL02-1/1
KM00321,0000A78 -19-13MAY20-1/1
Remove Paint Before Welding or Heating
Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint is heated
by welding, soldering, or using a torch.
Remove paint before heating:
•
Remove paint a minimum of 100 mm (4 in.) from area
to be affected by heating. If paint cannot be removed,
wear an approved respirator before heating or welding.
•
If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
•
If you use solvent or paint stripper, remove stripper with
soap and water before welding. Remove solvent or
paint stripper containers and other flammable material
from area. Allow fumes to disperse at least 15 minutes
before welding or heating.
Do not use a chlorinated solvent in areas where welding
will take place.
TS220
—UN—15APR13
Do all work in an area that is well ventilated to carry toxic
fumes and dust away.
Dispose of paint and solvent properly.
Avoid High-Pressure Jet on Safety Decals
The water jet can remove or damage safety decals. Avoid
to direct the water jet on safety decals.
Immediately replace missing or damaged safety decals.
Replacement safety decals are available from your
KEMPER dealer.
CC1021545
CC1021545
—UN—23APR02
05-8
061721
PN=16
Summary of Contents for 460plus
Page 6: ...Contents iv 061721 PN 4...
Page 108: ...Serial Number 80 2 061721 PN 108...
Page 111: ...Index Index 3 061721 PN 3...
Page 112: ...Index Index 4 061721 PN 4...
