Attaching to a CLAAS Forage Harvester
KM00321,0000AB4 -19-06MAY21-1/1
KM00321,0000AB9 -19-15JUN20-1/1
KM00321,0000204 -19-18AUG09-1/1
KM00321,00008B5 -19-25FEB19-1/1
Compatibility Chart
CAUTION: Before attaching the rotary harvesting
unit to a forage harvester, carry out the
steps included in Section Preparing the
Rotary Harvesting Unit.
The rotary harvesting unit is prepared for installation on
the following CLAAS forage harvester types:
Rotary harvesting unit/CLAAS forage harvester compatibility chart
460plus StalkBuster™
..............................................................
930 Type 502
940 Type 502
950 Type 502
960 Type 502
970 Type 502
980 Type 502
Tire Combinations
NOTE: The optimum angle of the header is in a
range between 10.5° and 11.5°.
To achieve the optimum angle of the header, the following
tire combinations are recommended for the forage
harvester:
930-980 series forage harvesters (type 502)
Front tire type
Rear tire type
900/60 R 32 Mitas SFT
600/65 R 28 Mitas IMP
900/60 R 32 Trelleborg TM 2000
600/65 R 28 Mitas IMP
900/60 R 32 Trelleborg TM 2000
600/65 R 28 Trelleborg
800/70 R 32 Michelin MEGAXBIB
600/65 R 28 Mitas IMP
800/70 R 32 Michelin MEGAXBIB
600/65 R 28 Trelleborg
Ballasting Harvester
Before attaching the rotary harvesting unit, make sure
harvester is ballasted correctly.
IMPORTANT: Always refer to the information given
in Wheels and Ballast Section of the forage
harvester operator's manual.
Adjust additional headlights on forage
harvester
IMPORTANT: When folding the rotary harvesting
unit, there is a risk of collision with the forage
harvester's auxiliary headlights (A).
To avoid a collision when folding the mower attachment,
adjust the forage harvester's auxiliary headlights (A) as far
outward as possible.
A—Auxiliary headlights
KM1002288
—UN—07MA
Y12
30-1
061721
PN=34
Summary of Contents for 460plus
Page 6: ...Contents iv 061721 PN 4...
Page 108: ...Serial Number 80 2 061721 PN 108...
Page 111: ...Index Index 3 061721 PN 3...
Page 112: ...Index Index 4 061721 PN 4...
