Attaching to a CLAAS Forage Harvester
KM00321,0000AB5 -19-06MAY21-1/5
Continued on next page
KM00321,0000AB5 -19-06MAY21-2/5
Attaching to a Type 502 Forage Harvester
with Variable Header Drive
Rotary harvesting units for the Claas type 502 forage
harvesters are technically partially prepared for the
variable header drive.
In addition, programming steps are required in the
forage harvester software, which must be matched
with Claas. Contact the Claas dealer concerning this.
IMPORTANT: To use the variable header drive, module
A130FAM must be programmed for the header
drive. Otherwise, the rotary harvesting unit
can only be used with constant speed and the
adjustment of the header speed is carried out
via the Kemper multi-speed gearbox.
NOTE: For rotary harvesting units that are equipped
for mounting a support wheel, first it is necessary
to delete the existing software on the rotary
harvesting unit module. Then the module
name A130FAM is visible.
Programming of the A130FAM module takes place via the
forage Harvester. To do so, proceed as follows:
1. Attach the rotary harvesting unit to the forage
harvester.
2. Connect the forage harvester to a computer and start
the Claas Diagnostics System (CDS).
3. Select the A130FAM module for programming the
rotary harvesting unit.
KM359969
—UN—22FEB19
4. When entering a serial number, enter
released by
Claas.
IMPORTANT: Enter a serial number of a rotary
harvesting unit that corresponds to the working
width of the Kemper rotary harvesting unit.
KM359968
—UN—22FEB19
30-2
061721
PN=35
Summary of Contents for 460plus
Page 6: ...Contents iv 061721 PN 4...
Page 108: ...Serial Number 80 2 061721 PN 108...
Page 111: ...Index Index 3 061721 PN 3...
Page 112: ...Index Index 4 061721 PN 4...
