Attaching to a FENDT Forage Harvester
KM00321,0000A86 -19-14MAY20-1/1
KM00321,0000ABA -19-15JUN20-1/1
Unlock the Oscillating Frame
Remove locking pin (A) and insert it in hole (B) in the
oscillating frame.
NOTE: The oscillating frame is now unlocked.
A—Locking Pin
B—Hole
KM1002267
—UN—29MAR12
Detaching the Rotary Harvesting Unit
NOTE: Fold the rotary harvesting unit before
setting it down.
1. Lower the rotary harvesting unit to the ground.
2. Shut off the forage harvester's engine, remove the key
from the ignition and apply the park brake.
3. Disconnect the pneumatic hose, electric connectors
and the hydraulic hoses (A) from the forage harvester
and store them in the bracket provided (B).
4. Pull off the driveshaft.
NOTE: Leave the rotary harvesting unit standing at
a height that allows the unit to be re-attached
to a forage harvester at a later time. Never
select a height that is too low.
5. Start the forage harvester and lower the rotary
harvesting unit until the dividing points touch the
ground.
6. At left and right, lower the jackstands (C) and lock
them at a suitable height. To do this, pull out the
spring-loaded pin (D) and let it re-engage when the
jackstand is at the correct height.
7. Open the brackets on the attachment frame.
8. Drain the feedroll housing and move it out of the
attaching frame of the rotary harvesting unit.
KM1000885
—UN—27MA
Y09
KM412036
—UN—14MA
Y20
A—Hydraulic Hoses
B—Bracket
C—Jackstand
D—Spring Pin
35-6
061721
PN=53
Summary of Contents for 460plus
Page 6: ...Contents iv 061721 PN 4...
Page 108: ...Serial Number 80 2 061721 PN 108...
Page 111: ...Index Index 3 061721 PN 3...
Page 112: ...Index Index 4 061721 PN 4...
