Lubrication and Periodic Service
KM00321,0000A94 -19-15MAY20-1/1
KM00321,0000A95 -19-15MAY20-1/1
Transmission Oil
Use oil with a viscosity based on the expected air
temperature range during the period between oil changes.
Transmission oils must meet API Service Classification
GL-5.
TS1653
—UN—14MAR96
Coolant for Main Drive Friction Clutch
The cooling system of the main drive friction clutch is
filled to provide protection against corrosion and freeze
protection to -37 °C (-34 °F).
Use a low silicate ethylene glycol base coolant
concentrate. The mixing ratio is 50% concentrate and
50% water.
The coolant concentrate must be of a quality that protects
the cast iron in the cooling system from cavitation
corrosion.
A 50% mixture of ethylene coolant in water provides
freeze protection to -37°C (-34°F). If protection at lower
temperatures is required, consult your KEMPER dealer
for recommendations.
Water quality is important to the performance of the
cooling system. Distilled, deionized, or demineralized
water is recommended for mixing with ethylene glycol
based coolant concentrate.
Coolant Change Intervals
Drain coolant from the main drive friction clutch, flush the
cooling system and refill with new coolant after the first 3
years or 3000 hours of operation. At each interval, drain
the coolant, flush the cooling system, and refill with new
coolant.
60-2
061721
PN=75
Summary of Contents for 460plus
Page 6: ...Contents iv 061721 PN 4...
Page 108: ...Serial Number 80 2 061721 PN 108...
Page 111: ...Index Index 3 061721 PN 3...
Page 112: ...Index Index 4 061721 PN 4...
