Operating the Rotary Harvesting Unit
KM00321,000052D -19-15NOV11-1/1
KM00321,0000156 -19-03APR09-1/1
Harvesting
Before the harvest, do the following:
- Unfold the rotary harvesting unit
- Check that the rotary cutter brakes are functioning
properly
- Adjust the feed bars
- Adjust the speed at which the gathering drums operate
IMPORTANT: Avoid unnecessary wear at the clutches.
Always select forward gear from the idle setting.
1. Run the forage harvester's engine at idle speed.
2. Switch on the rotary harvesting unit.
3. Wait until the gathering drums and rotating blades
have reached their operating speed.
IMPORTANT: In most cases, it is best to approach
the crop at right angles to the direction
it is lying in. This usually results in the
most even flow of crop.
IMPORTANT: Observe the flow of crop at all times.
4. Drive into the crop at a relatively high speed in order
to achieve a flow of crop quickly.
KM1001799
—UN—1
1NOV1
1
Hydraulic System
The hydraulic pressure must not exceed 21000 kPa (210
bar; 3046 psi).
KM1000850
—UN—03APR09
45-14
061721
PN=70
Summary of Contents for 460plus
Page 6: ...Contents iv 061721 PN 4...
Page 108: ...Serial Number 80 2 061721 PN 108...
Page 111: ...Index Index 3 061721 PN 3...
Page 112: ...Index Index 4 061721 PN 4...
