- 30 -
3.2.5 Temperature overview
You can use the navigation point "Overview" in the "Recording" mode to see all the
temperature sensors in an overview. They are colour highlighted according to the operating condition.
3.2.6 Temperature fault (exceeding or undercutting)
If the temperature for the range to be monitored happens to undercut or exceed the
set-point range, that fact is indicated by the flashing fault alarm signal on the control
cabinet and by the orange highlighted "Recording" tab. However, this warning is not
shown in the "Error Messages" It is merely recorded in the temperature log.
The warning message can be forwarded to, e.g., a BMS through Relay
–
K3.
