- 17 -
3.1.3 Adding components
To be able to properly add hardware, please proceed as follows:
Go to the "Add Components" tab. Set the installed components as, for instance, in the sample project, and apply
them with "OK".
3.1.4 Configuring A-valves
To be able to properly configure A-valves, please proceed as follows:
Go to the "A-valves" navigation point. Select the A-valve you want to configure by clicking on it and confirm the
"Change current valve setting" button. Until you do that, the "Configuration" button is not active.
As you can see in the symbolic representation in the sample project, there are three A-valves with the channel
numbers 101, 102 and 103. In this case, Channel 1 (101) has A-valve 1, is linked with Temperature sensor 2 and B-
valve 1 and is triggered via temperature control. Volume flushing can only be set after the corresponding B-
valve has been assigned to a volume sensor. You also have a facility for editing the comments and the names as
you desire. Subsequently confirm the changes with "OK". To add A-valve 2 and A-valve 3, proceed likewise. A-
valve 2 is assigned Channel 2 (102) and A-valve 3 to Channel 3 (103).
