- 20 -
3.1.8 Configuring temperature sensors
As shown in the sample project, in total two volume temperature sensors should be added.
To be able to configure it, select the "Temperature sensor" navigation point and click on
the corresponding sensor on "Edit".
In this case we have two temperature sensors. One branch sensor and one inlet sensor.
Assign the sensor a channel number and the corresponding type. In this case, this is a
branch sensor on Channel 2 (102), which is responsible for the temperature triggering of A-valve 1.
You also have a facility for editing the comments and the names as you desire.
Confirm the changes by pressing "OK". Proceed likewise for additional sensors.
3.1.9 Configuring the hygienic flushing
To be able to properly configure hygienic flushings, please proceed as follows:
Go to the "Hygienic flushings" navigation point. Select the hygienic flushing you want to configure
by clicking on it and confirm the "Change current valve setting" button.
Until you do that, the "Configuration" button is not active.
