18 / 32 – K410068602012-00 / 05.2019 –
©
www.kemper-olpe.de
Do not use the product for other purposes
than described above.
Only use the KHS Timer-Set
- in sound condition
- as intended
Warranty
Warranty or liability are voided through:
- Disregard of installation instructions.
- Damage due to faulty installation.
- Unauthorised product modifications.
- Other incorrect operation.
Warning information
Please read and follow the warning informa-
tion in this instruction. Disregard of the war-
ning information may lead to injury or mate-
rial damage!
Labelling of important warning information:
Danger!
Electricity!
Indicates hazards that might
result in severe or fatal injury.
Note!
Indicates hazards that
may lead to damages to the
system or malfunctions.
Important notes for the system operator
Maintenance
Annual inspection of the floa-
ter switch is recommended.
EN
Safety instructions for installation
Installation and use
Read the manual carefully and follow the in-
structions before installation!
Provide manual to the plant operator and
keep on hand for further reference!
Warning!
Installation must be carried out by
qualified plumbers and electricians.
The prerequisite for operating the controller
is the deployment of professionally trained
personnel (see EN 50 110-1, in the ELT sector
as well as potable water installations in ac-
cordance with TRWI DIN 1988).
Before commissioning, make sure the pota-
ble water and electrical installation has been
made professionally:
• The connections were made properly and
professionally and
• The plant is properly protected.
Follow all applicable regulations (ELT, SAN...)
and the regulations from the local utilities.
Warning!
Priority must be given to the nati-
onal standards and provisions accident pre-
vention.
Use
The KHS Timer-Set is used:
• for controlled isolation of water installa-
tions and for time based water exchange
to maintain an intended use.
• for connection of 10 parallel operated
valves und one optional KHS Drain with
overflow monitoiring (Fig. 688 00).
• in combination with Fig. 685 15 additi-
onally suitable as a terminal drain valve
(also without flow limiter) up to 5m/s.
