Safety
KM00321,000026B -19-20JAN14-1/1
KM00321,0000903 -19-02APR19-1/1
DX,PAINT -19-24JUL02-1/1
Transport with Harvesting Unit Installed
Before driving forage harvester on public roads, raise
harvesting unit and secure it in its fully raised position. It
must not, however, obstruct operator's view of the road.
In case of harvesting unit equipped with the crop deflector,
always store the deflector in its transport position before
driving on the road.
In case of harvesting unit equipped with the roller
compression unit, always store the roller compression unit
in its transport position before driving on the road.
ZX1050675
—UN—06DEC13
Ballasting for Safe Ground Contact
Operating, steering and braking performance of forage
harvester can be considerably affected by attachments
which alter the center of gravity of the machine. To
maintain safe ground contact, ballast the harvester at the
rear end as necessary. Observe the maximum permissible
axle loads and total weights.
KM23921
1
—UN—18MAR15
Remove Paint Before Welding or Heating
Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint is heated
by welding, soldering, or using a torch.
Remove paint before heating:
•
Remove paint a minimum of 100 mm (4 in.) from area
to be affected by heating. If paint cannot be removed,
wear an approved respirator before heating or welding.
•
If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
•
If you use solvent or paint stripper, remove stripper with
soap and water before welding. Remove solvent or
paint stripper containers and other flammable material
from area. Allow fumes to disperse at least 15 minutes
before welding or heating.
Do not use a chlorinated solvent in areas where welding
will take place.
TS220
—UN—15APR13
Do all work in an area that is well ventilated to carry toxic
fumes and dust away.
Dispose of paint and solvent properly.
05-8
022520
PN=17
Summary of Contents for Pickup C3003
