Operating the Pickup
KM00321,00009F7 -19-10FEB20-3/3
KM00321,00009F8 -19-10FEB20-1/1
Continued on next page
KM00321,00009F9 -19-10FEB20-1/2
3. Slowly lower the roller compression unit (A).
NOTE: Gauge wheels are automatically unlocked and can
turn freely when they are lowered onto the ground.
Lower the pickup onto the ground and drive the forage
harvester forward until gauge wheels are swiveled into
driving position.
A—Roller Compression Unit
KM371487
—UN—10FEB20
Operating the Roller Compression Unit
The Contact pressure of the roller compression unit is
adjusted by the oil pressure in accumulator (A).
CAUTION: Accumulator (A) may only be detached
or put into operation by hydraulically trained
engineers or technicians. Do not perform
any welding, soldering or other mechanical
work on the accumulator.
Raise roller compression unit so that roller (B) on the roller
compression unit does not push the crop up but always
lies on top of the windrow (see illustration).
NOTE: The oil pressure in accumulator (A) leads the
roller compression unit on the windrow.
A—Accumulator
B—Roller
KM404040
—UN—10FEB20
KM404041
—UN—10FEB20
Adjusting Rake of Roller Compression Unit
Position rake (A) in the holes (B) on both sides in such a
way that the tips of rake (A) are always aligned parallel
to the pickup cylinder.
NOTE: First position rake (A) in front hole (B).
Check alignment to the pickup cylinder and
adjust if necessary.
A—Rake
B—Hole
KM402919
—UN—22JAN20
45-5
022520
PN=43
Summary of Contents for Pickup C3003
