Attaching the Pickup
KM00321,0000672 -19-23JUN17-1/1
Adjust Jackstand Height
When installing the pickup on a forage harvester for the
first time, it is necessary to adjust the height of jackstands
(A) in relation to the size of the tires on the harvester. To
do this, it is necessary to take off the outer shields at left
and right.
There are several positions for screw (B).
•
Screw (B) is installed in the third borehole when it
leaves the factory.
•
When the forage harvester is equipped with 42-inch
tires, install screw (B) in the upper borehole (C).
•
On all other tire configurations, take out screw. Lower
pickup to a suitable height and re-install screw (B) in
the appropriate borehole.
•
Re-install shields at left and right.
A—Jackstand
B—Screw
C—Upper Borehole
KM318942
—UN—19JUN17
30-1
010421
PN=28
Summary of Contents for Pickup N3003
Page 4: ...Introduction 010421 PN 4...
Page 6: ...Introduction 010421 PN 6...
Page 67: ...Index Index 3 010421 PN 3...
Page 68: ...Index Index 4 010421 PN 4...
