Attaching the Pickup
KM00321,0000A61 -19-30APR20-6/7
KM00321,0000A61 -19-30APR20-7/7
KM00321,0000673 -19-23JUN17-1/1
9. At left and right, raise jackstand (I) and secure with
spring-loaded pin (A) in upmost position.
A—Jackstand
B—Pin
KM410683
—UN—24APR20
10. Connect driveshaft (A) to the forage harvester.
A—Driveshaft
KM410684
—UN—24APR20
Adjust the Scrapers
When installing the pickup on a forage harvester for
the first time, the clearance between auger flights and
scrapers must be adjusted.
Proceed as follows:
1. Slacken off nuts (A).
2. Move scrapers (B) forward to obtain specified
clearance between flight (C) and the scrapers (B).
Specification
Flight to
Scraper—Clearance...................................................................0—2 mm
(0—0.08 in.)
3. Retighten nuts (A).
4. Turn the auger by hand to make sure it can rotate freely.
IMPORTANT: The scrapers must be installed with
screw head facing down.
Ensure that the scrapers are parallel to
the auger at all times.
KM204378
—UN—06FEB14
A—Nuts
B—Scrapers
C—Flight
30-5
010421
PN=32
Summary of Contents for Pickup N3003
Page 4: ...Introduction 010421 PN 4...
Page 6: ...Introduction 010421 PN 6...
Page 67: ...Index Index 3 010421 PN 3...
Page 68: ...Index Index 4 010421 PN 4...
