Operating the Pickup
KM00321,0000A5A -19-22APR20-1/1
Continued on next page
KM00321,00009F9 -19-10FEB20-1/2
Operating the Windrow Compressor Roll
The contact pressure of the windrow compressor roll is
adjusted by the oil pressure in the pressure accumulator
(A).
CAUTION: The pressure accumulator (A) may
only be detached or put into operation by
engineers or technicians trained in hydraulics.
Do not perform any welding, soldering or other
mechanical work on the pressure accumulator.
Raise roller compression unit so that roller (B) on the roller
compression unit does not push the crop up but always
lies on top of the windrow (see illustration).
NOTE: The oil pressure in the pressure accumulator (A)
leads the windrow compressor roll on the windrow.
A—Pressure accumulator
B—Roller
KM409041
—UN—22APR20
KM404041
—UN—22APR20
Adjusting Rake of Roller Compression Unit
Position rake (A) in the holes (B) on both sides in such a
way that the tips of rake (A) are always aligned parallel
to the pickup cylinder.
NOTE: First position rake (A) in front hole (B).
Check alignment to the pickup cylinder and
adjust if necessary.
A—Rake
B—Hole
KM402919
—UN—22JAN20
45-4
010421
PN=41
Summary of Contents for Pickup N3003
Page 4: ...Introduction 010421 PN 4...
Page 6: ...Introduction 010421 PN 6...
Page 67: ...Index Index 3 010421 PN 3...
Page 68: ...Index Index 4 010421 PN 4...
