Operating the Pickup
KM00321,0000A04 -19-14FEB20-1/1
Roller Compression Unit Float Adjustment
When the roller compression unit is in operating position,
adjust float mode as follows:
1. First adjust downstop (A) in the slot holes so that the
stop (B) floats approximately 5 mm above the tube (C).
2. If the slot holes of downstop (A) are not sufficient for
adjustment, the valve (D) on the back can be adjusted
via a row of holes (E):
•
Set valve (D) higher to decrease space between
stop (B) and tube (C).
•
Set valve (D) lower to increase space between stop
(B) and tube (C).
3. Check float height of roller compression unit and make
fine adjustment as necessary.
A—Downstop
B—Stop
C—Tube
D—Valve
E—Holes
KM371489
—UN—1
1APR19
KM404047
—UN—14FEB20
KM404048
—UN—14FEB20
45-6
010421
PN=43
Summary of Contents for Pickup N3003
Page 4: ...Introduction 010421 PN 4...
Page 6: ...Introduction 010421 PN 6...
Page 67: ...Index Index 3 010421 PN 3...
Page 68: ...Index Index 4 010421 PN 4...
