Operating the Pickup
KM00321,00000F5 -19-23JAN09-1/1
KM00321,000029F -19-06FEB14-1/1
Adjusting Feed Auger Height
Adjust feed auger springs. (See Adjusting Feed Auger
Springs in this section.)
When feed auger arm (E) rests on the rubber stop (D), the
distance (G) between feed auger flight (A) and bottom
sheet (F) should be within specification.
Specification
Feed Auger
Flight to Bottom
Sheet—Distance..................................................................... 20 ± 5 mm
(0.8 ± 0.2 in.)
If the distance is not correct, proceed as follows:
1. Release feed auger springs (B) on both sides.
2. Raise the feed auger with a hoist.
3. Add or remove shims between rubber stop (D) and
support (C) to obtain the desired distance.
NOTE: The needed shims can be removed from
the lower rubber stop.
4. Adjust feed auger springs (B). (See Adjusting Feed
Auger Springs in this section.)
KM1000760
—UN—23JAN09
A—Feed auger flight
B—Spring
C—Stop support
D—Rubber stop
E—Feed auger arm
F— Bottom sheet
G—20 ± 5 mm (0.8 ± 0.2 in.)
Adjusting Feed Auger Springs
Adjust the correct length of feed auger spring (C).
To do this, tighten or loosen adjusting nut (B) to obtain
thread length (A) of 35—39 mm (1.4 in.—1.5 in.).
Repeat procedure on the opposite side.
NOTE: The feed auger spring adjustment described above
is a basic adjustment. Readjust according to field
conditions (reduce spring tension for high yield).
A—Thread Length
B—Adjusting Nut
C—Spring
KM204377
—UN—18OCT17
45-8
010421
PN=45
Summary of Contents for Pickup N3003
Page 4: ...Introduction 010421 PN 4...
Page 6: ...Introduction 010421 PN 6...
Page 67: ...Index Index 3 010421 PN 3...
Page 68: ...Index Index 4 010421 PN 4...
