DE
1502872-02
- 41 -
11. Die neue Filterpatrone (Pos. 4) einsetzen und mit der Sechskantmutter,
Dichtscheibe und Fächerscheibe (Pos. 5) laut Abbildung montieren.
Abb. 13: Wartungsdeckel verschließen
12. Das Produkt aufrichten und den Wartungsdeckel (Pos. 1) mit den zwei
Spannverschlüssen (Pos. 2) wieder verschließen.
13. Das Produkt durch Einstecken des Netzsteckers wieder mit dem
Stromnetz verbinden.
14. Produkt wieder in Betrieb nehmen. (siehe auch Kapitel
Inbetriebnahme)
7.3
Störungsbeseitigung
Störung
Ursache
Hinweis
Produkt läuft
nicht an
Fehlende Netzspannung
Durch Elektrofachkraft
prüfen lassen
Start-Stopp-Sensor
(optionale Ausstattung)
angeschlossen, jedoch
kein Schweißstrom
erkannt. Schweißprozess
noch nicht gestartet
Schweißprozess starten
Zugluft
Zugluft vermeiden