Kemppi 6300110, Operating Manual

EN

4. 

CONTROLLING WELDING FUNCTIONS

1

2

3

4

6

5

8

9

1

2

3

4

7

6

5

8

9

10

WIRE INCH

MANUAL

AUTOMATIC

个别

一元化

In the HF control panel you can adjust the welding current and welding voltage (V). The 

functions of these adjustments depend on whether you are using the power source in 

automatic or basic operating mode.
With the Wire inch button you can feed the filler wire into the welding gun.

4.1  Control panel functions in basic operation

If you are using the power source in basic operating mode without automatic functions, the 

control knobs have the following functions:

With the amperage knob (A)

 you can adjust the welding current and the wire feed speed. 

The wire feed speed increases with the amperage level.

With the voltage knob (V)

 you can adjust the welding voltage level. The voltage level 

determines the arc length.

4.2  Control panel functions in automatic operation

If you are using the power source in automatic operating mode, the power source takes care 

of adjusting the wire feed speed and the welding voltage according to the welding power you 

adjust. 
In automatic operating mode the control knobs have the following functions: 

With the amperage knob (A)

 you can set the welding power. The welding current, wire feed 

speed and the welding voltage are adjusted automatically according to this setting.

With the voltage knob (V)

 you can make fine adjustments to the welding voltage. The 

middle position of the knob is the default value.

9

© Kemppi Oy / 1217