EN
how to use the welding gun in 2t operating mode:
1.
Press the gun trigger down to start welding.
2.
Release the gun trigger to stop welding.
how to use the welding gun in 4t operating mode:
1.
Press the gun trigger down to start the flow of the shielding gas.
2.
Release the trigger to start welding.
3.
Press the trigger down again to stop welding.
4.
Release the switch again to stop the flow of the shielding gas.
4.1.4 Changing the wire feed speed adjustment scale
With the wire feed speed scale selector (4) you can affect the sensitivity of the control knob
when changing the wire feed speed.
•
If you want to use exact wire feed speed adjustment, select the adjustment scale 0…9
(max 9 m/minute).
•
If you want to use rough adjustment, select the adjustment scale 0…18
(max 18 m/minute).
4.1.5 using the power source remote control (only 300 rC)
ArcFeed 300RC model is equipped with a power source remote control function. It allows
you to adjust the power source current level straight from the work site. Remote control can
be used in constant current (CC) mode only. For more information on CC mode, see 4.1.2
“Selecting the CC or CV mode”.
to use the remote control
1.
Turn the selector switch (2) to up position (REMOTE) and keep it there.
2.
Select the desired welding current with the adjustment knob (1). The scale is suggestive
for Master 5001 power source.
3.
Release the selector switch.
ARCFEED
300RC
10
REMOTE
25
50
100 150 200300
400
A
1 adjusting knob
2
selector switch
12
A
rcF
eed 200, 300, 300P
, 300R
C / © Kemppi O
y / 1117
