EN
1.
preFACe
1.1
generAl
Congratulations on your choice of the Kemppi ArcFeed wire feeder. Used correctly, Kemppi
products can significantly increase the productivity of your welding, and provide years of
economical service.
This operating manual contains important information on the use, maintenance and safety of
your Kemppi product. The technical specifications of the equipment can be found at the end
of the manual.
Please read the manual carefully before using the equipment for the first time. For your
own safety and that of your working environment, pay particular attention to the safety
instructions in the manual.
For more information on Kemppi products, contact Kemppi Oy, consult an authorised Kemppi
dealer, or visit the Kemppi web site at www.kemppi.com.
The specifications presented in this manual are subject to change without prior notice.
important notes
Items in the manual that require particular attention in order to minimise damage and
personal harm are indicated with the
’NOTE!’
notation. Read these sections carefully and follow
their instructions.
disclaimer
While every effort has been made to ensure that the information contained in this guide
is accurate and complete, no liability can be accepted for any errors or omissions. Kemppi
reserves the right to change the specification of the product described at any time without
prior notice. Do not copy, record, reproduce or transmit the contents of this guide without
prior permission from Kemppi.
1.2
ABOut vOltAge-sensing teChnOlOgy
The voltage-sensing wire feeder uses the welding voltage to generate the energy required for
controlling the wire feeder’s operations. Before starting to weld, you just select the desired
settings for the feeder and the power source according to the welding requirements, the base
and filler material, and the shielding gas to be used.
When you start welding in CC mode, the feeder controls the parameters so that the quality of
the welds always remains high.
In normal MIG/MAG welding, the parameters’ values are controlled by the power source via
the control cable, but voltage-sensing technology makes such a control cable between the
power source and the feeder unnecessary.
Constant Current (CC) power sources
The CC type of welding machine changes the wire feed speed according to the arc voltage.
The voltage will change with different arc lengths while only slightly varying the amperage.
Constant voltage (Cv) power sources
The CV type of welding machine maintains a relatively stable, consistent voltage regardless of
the amperage. It results in a relatively flat volt-amp curve. The MIG/MAG welding machines are
typically CV type machines.
3
A
rcF
eed 200, 300, 300P
, 300R
C / © Kemppi O
y / 1117
