Service manual Minarc Evo 150 and 180
Version 1.3
30.9.2015
14
Kemppi Oy
Parameter values can be changed by using the buttons Remote ON/OFF and TIG/MMA separately.
Picrute3. Changing parameter value.
Increasing or decreasing the parameter value, affects the machine in different ways depending on the
parameter. Example above is for illustration only, s
ee the chapter “Calibration procedure” to get the step
by step instructions on how to proceed.
Parameter 3: Display
current offset min. (10A)
Increasing the parameter value:
Parameter 3: Display
current offset min. (10A)
Press to increase the parameter value
Press to decrease the parameter value