Ken A Vision Vision Viewer 7890B, Instruction Manual

7

Camera complies with Class A and B, part 15 of the FCC Rules.
Use only Ken-A-Vision Video Flex parts. The Power Supply and Charger are
made exclusively for the Video Flex. Failure to use non-Video Flex parts will
void your warranty.

INFORMATION TO THE USER  Changes or modifications not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.

NOTE:  This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with instructions,
may cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation.  If this
equipment does cause harmful interference to radio reception which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:  Reorient
or relocate the receiving antenna and/or increase the separation distance
between the equipment and the receiver, and/or connect equipment into an
outlet on a circuit different from that which the receiver is connected; and/or
consult your dealer or experienced radio/ TV technician for help.