![background image](http://html1.mh-extra.com/html/kencove/pd80/pd80_operators-manual_663681017.webp)
16
REV.3.20.14
Ram Cylinder Assembly
1.
Replace piston guide onto shaft and
secure into place with new locking nut.
2.
Slide shaft into open end of cylinder
body taking caution not to contact the
shaft with the cylinder body.
3.
Reinstall cylinder cap and securely
tighten.
SAFETY-SAFETY-SAFETY
IT IS IMPORTANT THAT ALL SAFETY
STEPS MENTIONED BELOW BE
FOLLOWED. FAILURE TO FOLLOW
THESE INSTRUCTIONS OR CONFORM
TO THE WARNING AND SAFETY
LABELS ON THE EQUIPMENT MAY
RESULT IN SERIOUS INJURY, DEATH,
AND/OR PROPERTY DAMAGE.
CAUTION! MAXUIM DRIVING FORCE
IS NOT REQUIRED TO DRIVE SMALL
DIAMETER WOOD OR STEEL POSTS.
1.
Personal protective equipment should
be worn at all times during operation.
This includes, but not be limited to,
safety glasses, hearing protection,
protective gloves, and steel toe
footwear.
2.
Safety equipment and safety labels are
NOT
to be removed from equipment.
Safety equipment and labels should be
inspected before each use and in
working condition during operation.
3.
Always be aware of the environment in
and around in which you are operating
in.
4.
Do not
modify the hydraulic lever
control valve or remove safety neutral
bracket.
5.
Be aware of underground utilities. If
unsure of locations, call your local
utility companies.
6.
Never
operate equipment on steep
slopes.
7.
The Post Driver operator is to
never
stand directly in front of equipment.
Stand to the valve side of equipment.
8.
Keep Hands Clear
of post and post
driver when driving a post.
9.
Maximum force of the Post Driver is
not to be use until the post being driven
is started into the ground and is
straight.
10.
If the post fails to drive into the ground
after two (2) or three (3) attempts,
move to another location. There could
be an underground obstruction; this
could cause the post to splinter and
cause injury to the operator.
11.
Post holder assembly is to be in the
open position at all times except when
driving a post, or during transportation.
12.
Driving posts is a
two (2) person
operation, an operator for the power
source equipment and an operator for
the post driver.
Never
attempt to
operate the post driver alone.
13.
Road lock pin is to be secure in lower
position before transporting more than
one-hundred (100) feet. During
storage secure road lock pin in top
hole.