![background image](http://html1.mh-extra.com/html/kencove/pd80/pd80_operators-manual_663681019.webp)
18
REV.3.20.14
6.
Release all pressure from the Post
Driver hydraulic system. Disconnect
the Driver’s 1/2” hydraulic pressure
hose to the equipment’s hydraulic
supply (pressure side). Disconnect the
Driver’s 3/4” hydraulic hose to the
equipment’s hydraulic return (non-
pressure side).
Dismounting for 3-Point Hitch
7.
Detach top link of 3 point hitch from
top mounting location of post driver
bracket.
8.
Detach two (2) lower, three-point hitch
lift arms from Post Driver three-point
category pins.
9.
Carefully pull away from the Post
Driver.
Ready to Drive a Post
WARNING! Personal protective
equipment should be worn during
all operating procedures. This
includes, but not be limited to, safety
glasses, hearing protection, protective
gloves, and steel toe footwear
WARNING! Driving posts is a two
(2) person operation, an operator
for the power source equipment and an
operator for the post driver. Never attempt
to operate the post driver alone.
WARNING! IT IS IMPORTANT
THAT ALL SAFETY STEPS
MENTIONED BELOW BE FOLLOWED.
FAILURE TO FOLLOW THESE
INSTRUCTIONS OR CONFORM TO
THE WARNING AND SAFETY LABELS
ON THE EQUIPMENT MAY RESULT IN
SERIOUS INJURY, DEATH, AND/OR
PROPERTY DAMAGE.
NOTE:
Lubricate four (4) guide blocks with
oil before each project and, during a project if
necessary. (Do not use grease)
KD-33
Lift valve lever out of Neutral Safety lock and
pull back hydraulic valve lever to raise ram.
1.
Position the equipment in place to
drive the first post.
2.
Tractor or power source equipment
must be placed in park if so equipped,
and parking brake must be set.
3.
Remove road lock pin and lower ram
until it comes in contact with the
rubber stops on main channel or the
ground.