714-630-7144
www.KendonUSA.com
- 7 -
12. Obey trailer cargo capacity limits. Go! Series Single Rail Transport limit -
1,000 pounds. Go! Series Dual Rail Transport limit - 2,000 pounds. Three
Rail/Dirt Bike Combo Trailer limit - 1,500 pounds. ATV / Utility Trailer limit
– 2,000 pounds (Pg. 13).
13. When towing the trailer empty, secure the rear section in folded position
using the rubber latch. Always stow trailer folded and secured when
empty (Pg. 19).
14. Trailer Limited Warranty (Pg. 29). Axle Limited Warranty (Pg. 30).
Thoroughly read and understand these instructions and the Owner
’s Manual
for your specific model
Go! Series™ Stand-Up™ Trailer, where applicable.
Un-Crating and Assembly Instructions
To ensure your satisfaction with our trailer, the removal of the trailer from the
crate and the installation of wheels and tail lights must be performed according
with the detailed instructions noted below. The assembly and installation
requires the basic knowledge and use of hand tools listed in the
“Recommended Tools” section. If you don’t feel you have the capacity to
perform this type of installation, or if you have any questions, please contact us
via phone at 714-630-7144, 800-847-8618 or via email at
info@kendonusa.com
.
Recommended Tools:
1. Pry Bar or Hammer
2.
13/16” or 21 mm Lug Wrench (for ½” Lug Nuts – Wheels & Spare Tire)
3.
7/16” or 11 mm Combination Wrench
4. Torque Wrench with 13/16
” or 21 mm Socket
5. Wire Cutters
6. Pliers
7. Box cutter or similar
Removal from Crate:
1. Carefully remove packaging, which may include shrink wrap, cardboard
packaging and bubble wrap, using a box cutter or similar tool.
BE
SURE to not cut on edges or near powder coated areas as to not
scratch the trailer framework.
2. Cut the metal retaining straps secured to axle and crate on each side of
the trailer.
3. Remove the tires, any additional boxes, parts and accessories from the
crate.
