-10-
-
Secure the taillight assembly to the mounting bracket using one
6mm stud on the back of the taillight and one supplied M6 nut
-
Place the round terminal ring over the remaining 6mm stud and
secure with the other M6 nut
-
Tighten both M6 nuts completely
-
Repeat this process on the other side
-
Your taillights should now be fully connected
-
Verify working operation prior to towing
4.6 Flip the Outer Casters
-
To protect the outer casters from damage during shipment, they
were installed upside down in the mounts; they must be flipped over
-
Hold the inside nut, close to the wheel, with a 3/4" wrench
-
Remove the outside nut with a 3/4" wrench or socket/ratchet
-
Remove the lock washer, flat washer, and caster
-
Flip the caster over and insert into the mounting bracket
-
Install the flat washer and lock washer
-
Hold the inside nut with a 3/4" wrench and install the outside nut with
a 3/4" wrench or socket/ratchet
-
Firmly tighten the outside nut
4.7 Flip the Loading Ramps
-
Loading ramps were shipped upside down to protect Ramp Hooks
-
Remove the loading ramps and install correctly prior to towing
4.8 Swing Out License Plate Holder
Your trailer came equipped with a Swing Out License Plate Holder to
eliminate clearance issues with the Rear Section and vehicles. Please
follow the included installation instructions.
4.9 Tighten Lug Nuts & Final Inspection
-
Connect your Kendon trailer to your tow vehicle as indicated in
Section 5.0
-
Using your lug wrench, torque the lug nuts to 60 ft-lbs. using a star-
shaped tightening pattern
