-11-
-
Make sure each lug nut is tightened to 60 ft-lbs.
-
Prior to towing perform a complete inspection to confirm:
o
Taillights are installed and working
o
Lug nuts have been completely tightened
o
All protective film has been removed
o
Loading ramps are stored and secured for towing
o
Coupler is completely locked and secured
o
Safety cables are connected
o
Rear section is latched closed (unless trailer is loaded)
o
There are no loose parts or tools on the trailer
Your Kendon Stand-
Up™ Trailer is ready for use. Register your trailer
and install a license plate as required by the laws of your state.
5.0 COUPLER, SAFETY CABLES, AND LIGHTS
Your Kendon Ride-Up SRL Trike/Spyder/Sidecar Stand-
Up™ Trailer is
equipped with a standard trailer ball coupler, braided steel safety cables,
and US DOT-approved taillights/turn signals. Before towing, always be
sure the coupler is properly closed and secured, safety cables are
connected, and all lights are working.
5.1 Coupler
-
Open the Coupler fully before
lowering onto your vehicle’s hitch ball
-
Carefully lower the Coupler onto the hitch ball, keeping all hands
and body parts away from any pinch points
-
Close the Coupler by pushing down on the Coupler handle
-
The latch on the coupler must fully engage the trailer tongue
-
The Coupler should be secured closed as illustrated here:
