-15-
-
Slide one section of loading ramp from beneath the Rear Section
and insert the Ramp Hooks into the Hook Loops
-
Unfold the short side of the ramp and insert the Ramp Hooks into
the Hook Loops
-
Slide the remaining loading ramp section from beneath the Rear
Section and insert the Ramp Hooks into the Hook Loops
-
Unfold the short side of the ramp and insert the Ramp Hooks into
the Hook Loops
-
Gently step on both sections of the loading ramp to be sure the
Hooks and Loops are fully engaged
7.2 Loading your vehicle
-
Before loading your vehicle, open the Swing Out License Plate
Holder by unscrewing the retaining pin on the top right of the Holder
-
Your license plate will swing open to eliminate clearance issues
-
Align your vehicle so the vehicle’s centerline is near the centerline of
your Kendon trailer
-
Gently and slowly ride or push your vehicle onto the trailer
-
Guide the vehicle onto the trailer between the Raised Front Rail on
each side, being careful to avoid contact with it
-
Vehicles with a single front wheel:
o
Carefully guide the front wheel into the center and front of
the Front Triangle
o
Advance your vehicle slowly so you do not jump the
vehicle’s front wheel over the Front Triangle
o
Ensure the front wheel is all the way forward in the Front
Triangle and straight
-
Vehicles with two front wheels:
o
Carefully guide the front wheels to the edge of the Raised
Front Rail
o
Advance your vehicle slowly so you do not jump the
vehicle’s front wheels over the Raised Front Rail
o
Ensure both front wheels are straight and contacting the
Raised Front Rail equally
-
Hold your vehicle in place for tie-
down with the vehicle’s parking
brake, leave it in gear, or place blocks behind the wheels
-
Secure your vehicle to the trailer using the tie-down procedure in
Section 8.0
