-3-
WARNING
: Properly attach the loading ramps
per this manual’s
instructions.
WARNING
: Obey trailer cargo capacity limits. Obey tow vehicle towing
and hitch capacity limits. Always consult your vehicle and trailer hitch
owner’s manuals before towing.
WARNING
: There is an inherent risk in the loading and unloading
process. Failure to load your vehicle properly could result in serious
injury and or property damage. Load and unload at your own risk.
WARNING
: Ramps must be properly secured to trailer prior to towing.
Ramps store below rear section on slide-out rails. Secure loading ramps
with locking padlocks or locking pins with wire retainers or similar
hardware. Check pins periodically and after stopping for security.
WARNING
: If towing two bikes with fairings, make sure both bikes are
firmly tied down giving separation between fairings. Failure to properly
tie down the motorcycles could cause fairings to collide while towing.
Trailer owner is responsible for complying with all the recommended
procedures in this instruction manual. Use at your own risk. Kendon is
not responsible for injury, liability, property damage and/or any
consequential damage(s) caused by the misuse of this product.
WARNING
: All motorcycles or other vehicles towed on trailer must be
firmly secured by a minimum of four (4) ratcheting tie-down straps.
Please consult Section 8.0
of this Owner’s Manual for proper tie-down
procedure. Kendon Industries, LLC is not responsible for damage or
injury caused by improper tie-down techniques. Never tow a vehicle
without at least four (4) tie-downs.
Trailer owner is responsible for complying with all recommended
procedures in this instruction manual. Use at your own risk.
Kendon Industries, LLC is not responsible for injury, liability,
property damage and/or any consequential damage(s) caused by
the misuse of this product.
2.0 GENERAL INFORMATION
Congratulations
on your purchase of a Kendon Stand-
Up™ Ride-Up
Motorcycle Trailer with SRL technology.
