23
12
CARE AND CLEANING
HOW TO CLEAN THE AIR PURIFIER FILTER cont.
4.
Shake the filter over a sink until excess water is removed and allow it to dip dry
completely allowing up to 24 hours before reinstalling filter back to the heater.
5.
DO NOT force the filter to dry using any alternative methods
6.
Reinstall the filter to the rear of the unit by positioning the filter back in place
CARE AND CLEANING TIPS
• Ensure that the heater is turned off (the switch on the back of the unit should be in
the off position. Unplug the power cord from the wall outlet before cleaning.
• Carefully wipe the exterior of the heater with a soft, damp (not wet) cloth and dry
thoroughly with a soft, dry cloth.
• Over time dust may accumulate on the front vent of the heater. This can be removed
by wiping with a damp cloth, or carefully cleaning using a vacuum cleaner with
brush attachment.
•
Do not use harsh or abrasive cleaners to clean your heater, as these will damage
the surface.
•
Clean the filter on the back of the heater every 30 days to maintain performance.
•
Do not run humidifier without water – this will void the warranty.
CAUTION:
disconnect power cord before servicing.
WARNING:
Any other service should be performed by a certified electrician
specialist or by authorized service representative.
WARNING:
The manufacturer shall not be liable in the event of
non-observance of the above instructions.
CAUTION AND REMINDER:
• The heater grill is hot when in use. To avoid burns, do not let bare skin touch the hot
surface. Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least three feet from the front of the heater and keep them
away from the sides and rear.
• Extreme caution is necessary when any heater is used by or near children or invalids
and whenever the heater is left operating and unattended.
• To disconnect heater, turn controls to off, then remove plug from outlet. Always
unplug heater when not in use.
PIEZAS Y CARACTERÍSTICAS
FUNCIONES DEL CONTROL REMOTO:
Fig. 3
FAN
HEATER
ROOM
SETTING
RS
DELAY
TIMER
TEMP
UP
DOWN
HUMIDIFIER
POWER
RS
UP
Botón de Encendido/
Apagado
Botón del
Ventilador
Botón para
Seleccionar
el Tamaño de
la Habitación
Botón del
Calentador
Botón para
Subir la
Temperatura
Presione el botón de HEATER para
encender o apagar la función de
calentamiento del calentador.
Presione el botón de POWER para
encender la unidad.
Presione el botón de FAN para
cambiar entre velocidad ALTA
a BAJA. Presiónelo de nuevo para
cambiar de BAJO a ALTO.
Presione el botón de ROOM
SETTING para ajustar el tamaño
de la habitación.
Presione el botón de TEMP UP para
subir la temperatura.
Presione el botón de HUMIDIFIER para
encender/apagar el humidificador.
Presione este botón para seleccionar
la cantidad de horas deseadas
Presione el botón de TEMP DOWN
para bajar la temperatura.
Botón para el
Humidificador
Botón para Bajar
la Temperatura
Botón para el
Temporizador
Programable
