12
A
C
B
D
HORIZONTAL EXHAUST INSTALLATION ONLY
A
B
Install the hood (EZ1 brackets)
NOTE:
The following procedure applies to both
framed or frameless cabinet installations.
1. Run house power cable between service panel and
hood location.
2. There are 2 pairs of recessed holes on each side of the
top of the hood (on rear:
A
and
B
, on front
C
and
D
on
illustration beside); these holes allow the range hood to
hang on the brackets (previously installed).
3. Temporarily hang the hood on the brackets using its
2 recessed REAR HOLES (
A
and
B
).
While holding the
hood
, run the house power cable into the hood through
the strain relief previously installed i
n step
5
on page 8.
4. Unhook the rear holes from the brackets and hang the
hood using its 2 recessed FRONT HOLES (
C
and
D
).
While holding the hood
, attach the power cable to the
hood using the strain relief
.
VERTICAL EXHAUST INSTALLATION ONLY
5. Hang the hood on the brackets using the 2 recessed
FRONT HOLES (
C
and
D
).
While holding the hood
, run
the house power cable into the hood through the strain
relief previously installed in step
5
on page 8. Attach
power cable to the hood.
DUCTED INSTALLATIONS ONLY
6. Connect the ductwork to the hood and use metal foil duct tape to make joints secure and air-tight. Make sure the
damper assembly (or round duct plate) enters the ductwork and that the damper opens and closes freely.
FRAMED CABINET
FRAMELESS CABINET
W
OOD
S
CREWS
M
ETAL
S
CREWS
7.
For framed cabinet
, secure the hood to the
EZ1 brackets using 4 no. 8-18 x 1/2” metal screws
(screws included in parts bag). Insert 2 screws per side,
in the slots (as shown in inset on illustration beside).
8.
For frameless cabinet
, secure the hood to the cabinet
using 4 no. 8 x 5/8” round head wood screws (screws
included in parts bag). Insert 2 screws per side, in the
slots (as shown in inset on illustration beside).