6
First Steps
This Use & Care Guide provides specific operating instructions for your model. Use the unit only as
instructed in this Use & Care Guide. Before starting the appliance, follow these important first steps.
NOTE
The exterior walls of the freezer may become
quite warm as the compressor works to
transfer heat from the inside. Temperatures as
much as 30°F warmer than room temperature
can be expected. For this reason it is
particularly important in hotter climates to
allow enough space for air circulation around
your freezer.
3” (75 mm)
3” (75 mm)
3” (75 mm)
3” (75 mm)
1” (25 mm)
Leveling
The freezer must have all bottom corners resting
firmly on a solid floor. The floor must be strong
enough to support a fully loaded freezer.
NOTE:
It is Very Important
for your freezer to be level
in order to function properly. If the freezer is
not leveled during installation, the door may
be misaligned and not close or seal properly,
causing cooling, frost, or moisture problems.
To Level Upright Models:
After discarding crating screws and wood base,
use a carpenter’s level to level the freezer from
front-to-back. Adjust the plastic leveling feet in
front, ½ bubble higher, so that the door closes
easily when left halfway open.
To Level Chest Models:
If needed, add metal or wood shims between
foot pads and floor.
Installation
• Choose a place that is near a grounded electrical outlet. Do Not use an extension cord or an
adapter plug.
• For the most efficient operation, the freezer should be located where surrounding temperatures
will not exceed 110°F (43°C). Temperatures of 32°F (0°C) and below will NOT affect freezer
operation. Additional compressor heaters are not recommended. The refrigerator must be
installed on a floor that is level and strong enough to support a fully loaded refrigerator.
• Allow space around the unit for good air circulation. Leave a 3 inch (75 mm) space on all sides
of the freezer for adequate circulation.
