Remove exterior and interior packaging, wipe the outside thoroughly with a soft dry cloth and the inside with a
wet, lukewarm cloth. Avoid placing the unit in a narrow recess or near any heat source, direct sunlight, or mois-
ture. Let air circulate freely around the unit. Keep the rear of the refrigerator 5 inches away from the wall.
1)
Select a place with a strong, level floor.
2)
Allow 5 inches of space between the back of the
refrigerator and any adjacent wall. Allow 2 inch-
es (minimum) all around the appliance.
3)
Avoid direct sunlight and heat. Direct sunlight
may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
4)
Avoid very moist places. Too much moisture in the
air will cause frost to form very quickly on the
evaporator, and your refrigerator will have to be
defrosted more frequently.
CHOOSING THE RIGHT LOCATION
INSTALLATION
Place the appliance firmly on a solid base. Some
appliances have adjustable feet on the front side;
use them to level the appliances.
CONNECTION TO POWER SUPPLY
Connect the appliance power cord and plug to a
properly grounded wall outlet. The required nominal
voltage and frequency are indicated on the rating
plate (inside the unit or on the exterior rear wall of
the unit).
BULB REPLACEMENT
Before replacing the light bulb, disconnect the appli-
ance from the power supply. Using a phillips screw-
driver, remove the screw located on the center side
of the light cover. Pull the light cover straight down.
Replacement light bulb must be the same wattage
as the original bulb.(15 watts only). Replace in
opposite order of removal.
INSTALLATION INSTRUCTIONS
5
