13
Complete Installation
1.
Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2.
Check that you have all of your tools.
3.
Dispose of/recycle all packaging materials.
4.
Be sure the water faucets are on.
5.
Check the dryer’s final location. Be sure the vent is not
crushed or kinked.
6.
Check that the dryer is level. See “Level Dryer.”
7.
For power supply cord installation, plug into an outlet.
8.
Remove the blue protective film on the door and any tape
remaining on the dryer.
9.
Read “Dryer Use.”
10.
Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
11.
Select a Timed Dry heated cycle, and start the dryer. Do not
select the Air Only Temperature setting.
If the dryer will not start, check the following:
■
Controls are set in a running or “On” position.
■
Start button has been pushed firmly.
■
Dryer is plugged into an outlet and/or electrical supply is
connected.
■
Household fuse is intact and tight, or circuit breaker has
not tripped.
■
Dryer door is closed.
This dryer automatically runs an installation diagnostic routine at
the start of its first cycle.
NOTE:
You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.
ENGLISH
Kenmore_Dryer-Good-02687A-01_EN.indd 13
2009-07-02 ¿ÀÈÄ 3:21:22
