12
3.
Clean clogged burner ports with a straight pin as shown.
Do not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact
a trained repair specialist.
4.
Replace the burner base. Each round burner base is marked
with a letter indicating the burner size. See the following
illustration for burner positions.
5.
Each round burner cap is marked with a letter indicating
the burner size. Replace the burner cap, making sure it is
properly aligned with the burner base. The burner cap
should not rock or wobble when properly aligned.
IMPORTANT:
The bottom of the small and medium caps
are different. Do not put the wrong size burner cap on the
burner base.
Small cap (P)
Medium cap (M)
Large cap (L)
6.
Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, turn off the
burner. Do not service the burner yourself. Contact a trained
repair specialist.
EZ-2-Lift™ Hinged Cast Iron Grates
The grates must be properly positioned before cooking. In the
proper position, the grates should be flush and level. Improper
installation of the grates may result in chipping or scratching
of the cooktop.
Your cooktop comes with hinged grates for easier cleaning.
The grates pivot upward and toward the back of the cooktop
for easy access under the grates.
The grates will stop once they are moved to their vertical (fully
open) position. A 20" (50.8 cm) minimum clearance from the
countertop to the bottom of the upper cabinets/appliances is
needed to fully open the grates.
Be sure to return the grates to their normal (down) position
once cleaning is complete.
The grates are removable for cleaning.
To attach the grates to their hinges, insert the grate slot over
the hinge pin on the back of the cooktop. Be sure to keep the
grate angled above the cooktop to avoid scratching the
cooktop until the grate is seated on the hinge pin. Then
position the grate down onto the cooktop.
Although the burner grates are durable, they will gradually
lose their shine and/or discolor due to the high temperatures
of the gas flame.
A
C
B
D
A. Small (P)
B. Large (L)
C. Medium (M)
D. Large (L)
A
B
A. Incorrect
B. Correct
B
A
A. Bumpers
B. Alignment indentations
A
B
A. Grate slot
B. Hinge pin
Summary of Contents for 664.4278 Series
Page 29: ...29 Notes ...