PREPARING FOR INSTALLATION
5
ENGLISH
PREPARING FOR
INSTALLATION
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conform with local codes, or
in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA.54, latest edition. In Canada,
installation must conform with the current Natural Gas
Installation Code, CAN/CGAB149.1 or the current Propane
Installation Code, CAN/CGA-B149.2, and with local codes
where applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest edition
and Canadian Gas Association according to CAN/CGA-1.1
latest edition.
As with any appliance using gas and generating heat, there
are certain safety precautions you should follow. You will
find these precautions in the important Safety Information
section in your Use & Care Guide. Read them carefully.
•
IMPORTANT
– Save these instructions for local
electrical inspector’s use.
•
IMPORTANT
– Observe all governing codes and
ordinances.
Note to Installer:
Leave these instructions with the
appliance after installation is completed.
Note to Consumer:
Keep the Use & Care Guide and
Installation Instructions for future reference.
NOTE: This appliance must be properly grounded.
• The electrical diagram is in an envelope attached to the
back of the range.
• Skill level – Installation of this appliance requires basic
mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
• Remove all tape and packaging.
• Make sure the burners are properly seated and level.
• Take the accessory pack out of the oven and/or drawer.
• Check to be sure that no range parts have come loose
during shipping.
Remove all tape and packing materials before using the
range.
Dispose of all plastic bags after unpacking the range.
Never allow children to play with packing materials.
You can download the Installation Manual and Use & Care
Guide at: http://www.kenmore.com
TOOLS NEEDED
Phillips screwdriver
Flat-blade screwdriver
Pencil and ruler
Open-end or
adjustable wrench
Pipe wrench (2)
(one for support)
Level
PARTS PROVIDED
Template (1)
(For Anti-Tip Bracket Mounted on
Concrete Floors and Walls)
Anchor Sleeves (4)
Anti-Tip Bracket Kit (1)
Lag Bolts (4)
MATERIALS YOU MAY NEED
• Gas line shut-off valve
• Pipe joint sealant that resists action of natural and LP
gases.
• Flexible metal appliance connector (3/4” or 1/2” NPT x
1/2” I.D.)
Never use an old connector when installing a new range.
• Flare union adapter for connection to gas supply line
(3/4” or 1/2” NPT x 1/2” I.D.)
• Flare union adapter for connection to pressure regulator
on range (1/2” NPT x 1/2” I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 1/2” O.D. sleeve anchor (for concrete floors
only)
Summary of Contents for 721.7603 series
Page 14: ...MEMO 14 MEMO ...
Page 27: ...MEMO 27 ESPAÑOL MEMO ...
