30
Oven Controls
Removing and Replacing the Warmer Drawer
To remove the warmer drawer:
Electrical shock hazard can occur and result in
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
1.
Turn power OFF to the appliance before removing the
warmer drawer.
2. Open the warmer drawer completely.
3. On left warmer drawer rail, locate black release lever and
press up with finger while pulling out slightly on the oven
drawer handle. On right warmer drawer rail, locate black
release lever and press down with finger while pulling out
slightly on the warmer drawer handle (See
Figure 39
).
4. The warmer drawer should now be released from the rails.
Remove warmer oven drawer (using level and square
motion) completely out and away from the appliance.
To replace the warmer drawer:
1.
Pull the bearing glides to the front of the outer compart-
ment glide channels until they snap into place (See
Figure 40
).
2. Carefully line up both sides of the warmer drawer glide
rails to the outer compartment glide channels located inside
the empty warmer drawer compartment (See
Figure 41
).
3. While holding the warmer drawer level and square using
the warmer drawer handle, push (do not force) the warmer
drawer all the way into the outer compartment glide
channels all the way into the range. Open the warmer
drawer again to verify the glides have seated.
4. If you do not hear the levers click or the bearing glides do
not feel seated remove the warmer drawer and repeat
Steps 1 through 3 again. This will minimize possible damage
to the bearing glides.
Figure 39: Removing the warmer drawer
Left-hand rail and release
Warmer
drawer
handle
Right-hand rail and release
Figure 40: Bearing glide placement
Figure 41: Channel alignment
Left-hand channel
Right-hand channel
Summary of Contents for 790.9507 Series
Page 42: ...42 Before You Call ...
Page 43: ......