15
REFRIGERATOR INSTALLATION
4 Place the cover (1) in its place. Insert and tighten
the cover screw (2).
Assembling the Left Refrigerator Door
Install the left refrigerator door after the right door is
installed.
1 Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator door
onto the middle hinge.
2 Fit the hinge (1) over the hinge lever latch and
slot it into place. Rotate the lever clockwise (2)
and fasten the hinge.
Hinge Lever Latch
3 Connect all the wire harnesses.
4 Push the water supply tube into the hole on the
top case and pull it through the backplate.
5 Hold the water supply connection and gently push
in the collet (1) to connect the water supply line
(2) as shown. Insert the tube at least 5/8 inch (15
mm) into the connector. Insert the clip on the joint
to fasten the tube in place.
Collet
6 Place the cover (1) in place. Insert and tighten the
cover screw (2).
NOTE
Disassembling/Assembling the Water Lines
Collet
Tube
Insert line
Clip
(Correct)
Gently press the collet and insert the tube until only
one line shows on the tube.
(Correct)
(Incorrect)
Summary of Contents for 795.7259
Page 1: ...795 7259 MFL68680470 Rev 00_082917 ...
Page 35: ...35 WATER FILTER ...