Kenmore 795.7410 Series, Use & Care Manual

10

REFRIGERATOR INSTALLATION

1.

  To avoid noise and vibration, the unit must be leveled 

and installed on a solidly constructed 

floor

. If required, 

adjust the leveling legs to compensate for unevenness 

of the 

floor

. The front should be slightly higher than 

the rear to aid in door closing. Leveling legs can be 

turned easily by tipping the cabinet slightly. Turn the 

leveling legs to the left to raise the unit or to the right to 

lower it. (See LEVELING AND DOOR ALIGNMENT.) 

NOTE: Installing on carpeting, soft tile surfaces, 

a platform or weakly supported structure is not 

recommended.  

2.

 Install this appliance in an area where the temperature 

is between 55°F (13°C) and 110°F (43°C). If the 

temperature around the appliance is too low or high, 

cooling ability may be adversely affected.

3. 

Select a place where a water supply can be easily 

connected for the automatic icemaker.

NOTE: The water pressure must be from 20-120 psi or 

138-827 kPa or 1.4-8.4 kgf/cm². If the refrigerator is 

installed in an area with low water pressure (below 20 

psi), you can install a booster pump to compensate for 

the low pressure.

4.

 Too small of a distance from adjacent items may 

result in lowered freezing capability and increased 

electricity consumption charges. Allow at least 24 

inches (61 cm) in front of the refrigerator to open the 

doors and at least 2 inches (5.08 cm) between the 

back of the refrigerator and the wall.  

INSTALLATION

The refrigerator should always be plugged into its own 

individual properly grounded electrical outlet rated for 

115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes. 

This provides the best performance and also prevents 

overloading house wiring circuits which could cause a 

fir

e 

hazard from overheated wires. It is recommended that a 

separate circuit serving only this appliance be provided.

REFRIGERATOR INSTALLATION

2" (5.08 cm)

Shock Hazard:

To reduce the risk of electric shock, do not install the 

refrigerator in a wet or damp area.

WARNING

This appliance is intended to be used in household and 

similar applications such as staff kitchen areas in shops, 

offices and other working environments; farm houses 

and by clients in hotels, motels and other residential 

type environments; bed and breakfast type 

environments; catering and similar non-retail applications.

PRIOR TO USE

1. Clean your refrigerator thoroughly and wipe off all 

dust that accumulated during shipping.

2. Install accessories such as ice cube bin, drawers, 

shelves, etc., in their proper places. They are packed 

together to prevent possible damage during shipment.

3. Allow your refrigerator to run for at least two to three 

hours before putting food in it. Check the flow of 

cold air in the freezer compartment to ensure proper 

cooling. Your refrigerator is now ready for use.