19
Automatic Ice Maker - Freezer
Operation & Care of the Freezer
Ice Maker (select models)
After the refrigerator is installed properly, the ice
maker can produce ice within 24 hours. It can
completely fill the ice bin in about three days.
When using the ice maker for the first time and
in order for the ice maker to work properly, it is
necessary to clear air from water filter tubing.
Once ice maker begins making ice, allow the
bucket to fill completely, then discard the first
TWO FULL buckets of ice. It will take at least
two days to completely fill the bucket on regular
ice making mode or 1
½
days on fast ice mode.
The ice maker produces approximately four
pounds of ice every 24 hours depending on
usage conditions.
Turning the Ice Maker On and Off
Ice
production
is
controlled
by lifting/
lowering
the ice
maker’s
wire signal
arm.
To gain
access to
the ice maker, pull the freezer drawer out. Lift
the wire signal arm to turn the ice maker OFF
and lower the wire signal arm to turn it ON.
Clean the ice maker and ice bin at regular
intervals, especially prior to vacation or moving.
1. Turn off the ice maker.
2. Remove the ice bin.
3. Empty and carefully clean the ice bin
with mild detergent. Do not use harsh
or abrasive cleaners. Rinse with
clean water.
4. Allow the ice bin to dry completely
before replacing in the freezer.
5. Replace the ice bin. Turn the ice
maker on.
Remove and empty the ice bin if:
• An extended power failure (one hour or
longer) causes ice cubes in the ice bin
to melt and freeze together.
Remove the ice bin and shake to loosen
the cubes or clean as explained above.
Ice maker tips
• If your refrigerator is not connected to
a water supply or the water supply is
turned off, turn off the ice maker by
lifting wire signal arm.
• The following sounds are normal when
the ice maker is operating:
- Motor running
Wire
Signal Arm
ON
OFF
IMPORTANT
Your ice maker is turned on at the factory
so it can work as soon as you install your
refrigerator. If you cannot connect a water
supply, lift the ice maker’s wire signal arm
to turn it off. Otherwise, the ice maker’s fill
valve may make a loud chattering noise
when it attempts to operate without water.
CAUTION
If the water supply to your refrigerator is
softened, be sure the softener is properly
maintained. Chemicals from a water
softener can damage the ice maker.
CAUTION
NEVER use an ice pick or similar sharp
instrument to break up the ice. This
could damage the ice bin.
To loosen stuck ice, use warm water.
Before replacing the ice bin, make sure
it is completely dry.
- Ice dropping into ice bin
- Water valve opening or closing
- Running water
• Ice cubes stored too long may develop
an odd flavor. Empty the ice bin as
explained below.
Quick Ice Function
Your refrigerator is equipped with a Quick Ice
Function, that increases ice production. This
function terminates automatically.
Quick Freeze Function
Your refrigerator is equipped with a Quick
Freeze Function that activates a faster
rate for freezing food.
Cleaning the Ice Maker
