7
Door Removal Instructions
Door Handle Mounting Instructions
1. Remove handle from carton and any
other protective packaging.
2. Position handle end caps over upper
and lower pre-installed shoulder
bolts (A) that are fastened into door,
ensuring the holes for the set screws
are facing towards the outside of
door if it is a single unit installation,
or towards the refrigerator door if
installing the matching refrigerator.
3. While holding handle firmly against
door, fasten upper and lower Allen
set screws (B) with supplied Allen
wrench.
4. Repeat steps 2 and 3 to install
refrigerator handle (if installing the
matching refrigerator). Ensure the
holes for the set screws are facing
towards the freezer door.
NOTE
All set screws should be tightened and
sub-flush of handle end cap (set screw is
seated just below the surface of handle
end cap). The end caps should be drawn
tight to appliance door with no gaps.
A
B
Single Unit Installation
Ensure Handle Set Screws
are Facing Each Other
With Doors Closed.
Matching Refrigerator and Freezer
Door Handle Installation
Kick Plate Removal
To remove the kick plate, use a Phillips
screwdriver and remove the two screws
holding the kick plate to the cabinet. Then
pull the kick plate away from the unit.
Remove Screws